Description
PHILIPS Smart LED Post-top BGP162 D520 30 4000K RAL7043 911401742524
PHILIPS 911401742524 30 W 4000 K RAL7043 4,200 lm IP66 · IK08
BGP162 D520 in 30 W, 4000 K and RAL7043 dark grey — 140 lm/W system efficacy, IP66/IK08, 500-hour salt spray, 50,000-hour L70B50 lifetime and pole-top mounting onto a Ø60 mm post.
Product Details
- 12NC
- 911401742524
- Ordering description
- BGP162 D520 30 4000K RAL7043
- Power consumption
- 30 W ±10%
- Colour temperature
- 4000 K
- Initial lumen output
- 4,200 lm ±10%
- Housing colour
- RAL7043 dark grey
- Dimensions
- Ø520 × 315 mm
- Mounting
- Pole top, Ø60 mm post
Why This Configuration
What the 30 W / 4000 K / RAL7043 combination is actually for.
30 W · 4,200 lm
4,200 lm at 140 lm/W — roughly the light an older 45 W post-top produced, at about a third less connected load. For close-spaced, pedestrian-scale layouts.
4000 K · neutral white
Neutral white — the CCT European road and car-park specifications are written around, and the CCT Philips publishes the lumen figures at.
RAL7043 · dark grey
Graphite grey that recedes against dark poles, wet asphalt and evening foliage, so the lit ring reads as a floating disc after dark.
Installation & Wiring
Pole interface
Slides onto a Ø60 mm post. Base Ø90 mm outside, minimum Ø61 mm inner bore, 65 mm of engagement — no adapter needed.
Wiring
Factory-fitted 0.5 m three-pole round rubber cable, 3 × 1.0 mm², single flying wires. Terminate inside the pole handhole.
Circuit loading
Approximately 0.15 A per luminaire at 230 V, calculated from 30 W at a power factor of 0.9 (worst case). Size the circuit and any timer contactor against that figure.
Earthing and surge
Safety Class I — protective earth required. Surge protection L-N 2 kV and L/N-PE 4 kV built in; ETO raises this to 10 kV.
Isolate the circuit before opening the pole handhole. This version is on/off only — it has no dimming input, so do not wire it to a dimmer or a DALI line.
Technical Specifications
| System | |
| Order code (12NC) | 911401742524 |
| Colour temperature | 4000 K |
| Initial lumen output | 4,200 lm ±10% |
| System efficacy | 140 lm/W |
| Power consumption | 30 W ±10% |
| Colour rendering index | CRI >70 |
| Colour consistency | ≤5 SDCM |
| Lifetime (ta 35 °C) | 50,000 h L70B50 |
| Operating temperature | −40 °C to +50 °C |
| Operating humidity | Up to 95% |
| Electrical | |
| Safety class | Class I |
| Input voltage | 220–240 V AC, 50/60 Hz |
| Power factor (full load) | ≥0.9 |
| Surge protection | L-N 2 kV; L/N-PE 4 kV |
| Driver | Built-in |
| Control interface | On/off |
| Power connection | 3-pole round cable L = 0.5 m, 3 × 1.0 mm², single flying wires |
| Mechanical & appearance | |
| Dimensions (Ø × H) | Ø520 × 315 mm |
| Weight | 4.8 kg |
| Salt spray | 500 hours |
| Ingress protection | IP66 |
| Impact protection | IK08 |
| Housing material | Die-cast aluminium |
| Cover material | Polycarbonate, anti-UV |
| Housing colour | RAL7043 dark grey |
| Certification | CQC; CE / CB / EMC / LM79 |
Product Gallery
Both housing colours share the same optical system, dimensions and pole interface — the shots below cover the two RAL finishes and the mounting detail.
Riverside footpath, residential districtBGP162 post-top luminaires on Ø60 mm poles, symmetric ground coverage without glare.
RAL7040 light grey, seen from belowLooking up into the lit luminaire: the flat PC optic ring emits evenly through 360°, three-arm carrier above the pole.
RAL7043 dark grey, side elevationSwitched off: 315 mm height, finned die-cast top, three-arm carrier and the Ø90 mm base for a Ø60 mm pole.
Top view — die-cast heat sinkThe finned die-cast ring sheds heat from the LED board; three-arm carrier centres the Ø61 mm pole bore.
Complete Product Lineup
All 12 standard order codes. The row highlighted in yellow is this BGP162 D520 30 4000K RAL7043.
| 12NC | Description | Power | CCT | Housing |
|---|---|---|---|---|
| 911401742514 | BGP162 D520 30 3000K RAL7043 | 30 W | 3000 K | RAL7043 |
| 911401742524 | BGP162 D520 30 4000K RAL7043 | 30 W | 4000 K | RAL7043 |
| 911401742534 | BGP162 D520 40 3000K RAL7043 | 40 W | 3000 K | RAL7043 |
| 911401742544 | BGP162 D520 40 4000K RAL7043 | 40 W | 4000 K | RAL7043 |
| 911401742554 | BGP162 D520 50 3000K RAL7043 | 50 W | 3000 K | RAL7043 |
| 911401742564 | BGP162 D520 50 4000K RAL7043 | 50 W | 4000 K | RAL7043 |
| 911401742574 | BGP162 D520 30 3000K RAL7040 | 30 W | 3000 K | RAL7040 |
| 911401742584 | BGP162 D520 30 4000K RAL7040 | 30 W | 4000 K | RAL7040 |
| 911401742594 | BGP162 D520 40 3000K RAL7040 | 40 W | 3000 K | RAL7040 |
| 911401742604 | BGP162 D520 40 4000K RAL7040 | 40 W | 4000 K | RAL7040 |
| 911401742614 | BGP162 D520 50 3000K RAL7040 | 50 W | 3000 K | RAL7040 |
| 911401742624 | BGP162 D520 50 4000K RAL7040 | 50 W | 4000 K | RAL7040 |
This order code is one of twelve in the PHILIPS Smart LED Post-top BGP162 series — 30 / 40 / 50 W, 3000 K and 4000 K, in RAL7043 dark grey or RAL7040 light grey. The series page carries the full specification table, the BGP162 vs BGP161 comparison and the ETO options.
Also from PHILIPS Outdoor & Urban Range
Complementary luminaires for the same schemes — poles, bollards, floodlighting and street lighting.
PHILIPS BGP312 LED Lawn Light
PHILIPS UniBollard BCP322
PHILIPS BVP150 G4 LED Floodlight
PHILIPS BRP26X Street Lighting
PHILIPS BGP150 G2 LED Spotlight
PHILIPS BRC010 Solar Street Light
PHILIPS WT198C Waterproof G3
PHILIPS BY175P G2 LED HighbayFrequently Asked Questions
What does the 4000 K version give me compared with the 3000 K version?
Both run the same 140 lm/W platform and differ only in colour temperature, so the 30 W 4000 K and 30 W 3000 K versions carry the same nominal output. Philips publishes initial lumens at 4000 K (4,200 / 5,600 / 7,000 lm for 30 / 40 / 50 W); the 3000 K version shares that efficacy figure. Pick 3000 K for residential edges and heritage streets, 4000 K where a neutral white is specified.
Can this 30 W version be dimmed?
No — the standard BGP162 D520 30 4000K RAL7043 is on/off only, and the integral driver has no dimming input. 0-10 V dimming or DALI-2 DT6 is available as an engineered-to-order variant on the same housing, together with up to 100 W, 2200 K / 2700 K / 5000 K and 10 kV surge protection. ETO variants carry a minimum order quantity and are quoted per project.
What exactly does 911401742524 cover, and which pole do I need?
The 12NC covers the luminaire only, in RAL7043 dark grey, with a factory-fitted 0.5 m three-pole cable. No pole is included. The base is Ø90 mm outside with a minimum Ø61 mm bore and 65 mm of engagement, so it slides onto a standard Ø60 mm post. Safety Class I — a protective earth is required. The other housing colour of the same wattage and CCT is BGP162 D520 30 4000K RAL7040.
